For lifting equipment OEMs, uptime depends on more than rugged hardware. Cranes, telehandlers, aerial lifts, forklifts, and access platforms rely on coordinated control of lift, lower, extend, retract, swing, tilt, stabilizer, outrigger, platform-position, attachment-state, and enable logic. HED helps OEMs move those critical functions into a more integrated control architecture where controllers, I/O, displays, CAN keypads, diagnostics, and machine-state feedback work together instead of being buried in hardwired circuits.
-
Smarter controls help keep lift-critical functions available, visible, and easier to service. Reduce faults tied to long routing paths, crowded pass-throughs, excess splices, corrosion-prone connections, and hard-to-trace point-to-point wiring.
- Use module-level diagnostics to isolate problems by function area instead of forcing technicians to chase wires across the machine.
- Give operators and service teams clearer visibility into machine status, warnings, abnormal conditions, and fault states through displays and intelligent operator interfaces.
- Coordinate interlocks and enable logic for stabilizers, outriggers, platform position, lift functions, attachment state, chassis conditions, and other safety-related machine states.
- Support faster first-time diagnosis, fewer repeat service events, and better uptime confidence for end customers who depend on the machine to work when scheduled.
For lifting equipment, HED’s value is not just replacing wires with electronics. It is helping OEMs design a smarter machine-control foundation that keeps critical work functions coordinated, diagnosable, and serviceable over the life of the platform.
Read more: Bottom-line impact of simplifying electrical architecture